M5Stack Grove to Dupont cable (A096) – for mmWave sensors

This cable solves one of the most common problems when mixing brands: M5Stack uses the Grove connector, while most radar sensors and modules have loose pin headers.

The cable has a Grove connector at one end and four separate female Dupont connectors at the other, so you can connect VCC, GND, TX and RX individually, with no soldering and no breadboard.

Used for

• LD2410C and LD2450 mmWave sensors
• Most UART and I2C modules with a 2.54 mm pin header

Good to know

Check the pinout before connecting. On the Grove connector, black is normally GND and red is 5 V; you may need to swap the two signal wires depending on whether the sensor's TX should go to the controller's RX.

Manufacturer: M5Stack Technology Co., Ltd, Block A10, Expo Bay South Coast, Fuhai Street, Bao'an District, Shenzhen, China, [email protected]. EU representative: Success Courier SL, Calle Rio Tormes 1, Planta 1, Derecha, Oficina 3, 28947 Fuenlabrada, Madrid, Spain, [email protected].

End-of-life electronics must be taken to separate collection. Read about e-waste.